Skip to main content
Skip table of contents

User not assignable

Symptoms

An issue does not get synchronized and appears in the troubleshooting section with the category 'User not assignable' and the message, e.g. '"assignee":"User 'ag1' cannot be assigned issues."'.

The 'assignee' part identifies the internal id of the field which is affected.

Cause

A user was set to the issue in the sender project and no user with the same name is assignable in the receiver project. At this point of time, backbone only supports mapping user with the same names to each other.

Resolution

The following steps should be done in order to resolve this problem.

  • Check if the user exists and is assignable to the issue. The user needs the 'Assignable User' permission.
  • Check if the user is active which is required to assign it to an issue.
  • After fixing your configuration please perform a retry.
JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.